Chinese CDI for 250cc Scooters. Known to fit s Diamo Linhai Roketa Turista TBX and more. Use pictures & measurements to match your CDI; CDI description: Single 6-pin plug. Box of CDI measurement: 87mm x 70mm x 24mm (3.4

Chinese CDI – 6-Pin – Single Plug – Version 32 – 250cc Scooter

 Set details: Ignition switch, trunk lock and locking gas cap. Ignition switch mounting holes measure 29mm center to center. Wiring harness is 7 inches long, 5-wire with a 5 spade connector as pictured. 3 position ignition switch. Trunk lock cable is 9 inches long. Known to fit a Gator 50, Roketa MC-10-50, Baotian Scout 49/50, Superbyke, BTM, Jmstar and Peugeot.

Chinese Ignition Key Switch Set Version 18 for GY6 50cc – 150cc Scooters Mopeds

Chinese ATV Disc Brake Pad Set Version 9
Chinese CVT drive belt fits many 4-stroke models of ATVs, dirt bikes, go karts, scooters, and mopeds, including Linhai 250. This belt is specially designed for a variety of motorized CVT applications. Belt description: CVT [-Continuous Variable Transmission-] Fits 250cc Scooters, Mopeds, Go Karts, CVT ATVs Length: 871mm / 34.29

Chinese CVT Drive Belt – [871-23-30] – Version 13

 This Chinese 2-bolt starter is the replacement part for many 4-stroke Chinese GY6 50cc Scooters. This starter fits GY6 50cc models. Starter description: 2-bolt 10 tooth Bolt hole measurement: 70mm [2.75

Chinese Starter – GY6 50cc Scooter Engine – Version 9

Chinese ATV 12 Volt Battery Version 4
This is a complete fender set for the VX style/model of ATVs. 6 piece set. Please check the pictures and measurements close to insure a correct fit on your machine. Rear fender details: Overall width: 82.55cm [32.5

Chinese ATV Front Rear Fender Set for VX – 6 piece – Blue

 Clutch assembly (#11) is usually used on water cooled 250cc 260cc Chinese manufactured brands and models. Also used on the Hart Karts with the 300cc engine. Known to fit Manco, Talon, Linhai, Buyang, Roketa, and many more. Please measure and compare before ordering. Clutch details: Rear clutch for 250cc-300cc engine 16 splines inside the clutch drum/bell 16mm ID spline shaft Uses LARGER spline shaft than found on most machines Fits 250-300cc Known to fit water cooled 250cc-300cc full auto with CVT tranny ATVs, scooters, go karts. Check pictures and measurements to be sure this is the correct clutch for your application.

Chinese Clutch Assembly – 16 Spline – 260cc Linhai Scooter – Version 11

 Chinese 200cc-250cc intake manifold fits many 4-stroke models of ATVs, dirt bikes, go karts, scooters, and mopeds. Check pictures and measurements to verify this one will fit your machine/engine. Measurement on bolt holes are center-to-center. Manifold description: Bolt hole measurement: 62mm [2.44

Chinese ATV Carburetor Intake Manifold Version 8 for 200cc – 250cc